F FRAMEFORGE 3.0 SNAP
Private · generated on device
REAR ASSEMBLY — EXPLODED VIEW● BED CHECK PASSED
YOUR
PICTURE
FRAMEBACKER + 2 HINGE KNUCKLESLEG + CENTER KNUCKLEHEADED HINGE PIN →
↔ 188.4 mm
↔ 137.6 mm
OUTER SIZE188.4 × 137.6
POCKET STACK4.5 mm
EST. MATERIAL0 g
PRINTABLE PARTS0

Pictorial assembly guide

From print bed to finished frame.

The diagrams show the rear of the frame. This kit is configured for landscape display.

  1. 1. Stack the picture

    Frame face-down: add glazing, optional mat, artwork face-down, then the backer.

  2. ↓
    2. Snap in the backer

    Press the center of each edge until all four retaining latches engage.

  3. →
    3. Join the three knuckles

    The backer has two landscape outer knuckles. Put the leg’s center knuckle between them, then pass the headed pin through all three.

  4. 4. Open or fold

    Swing the landscape leg out for tabletop display. Fold it flat for storage or hanging.

  5. •
    5. Hang securely

    Use the landscape keyhole. Insert an anchored screw head through the round opening, then lower the displayed frame into its narrow locking channel.

Orientation-specific hardwareThe hinge axis, folding leg, pin, and permanent hanger are generated for the selected landscape display direction.

Validated STL set

Building solids…